ProForm Zt3 Treadmill English Manual - Page 11
If You Do Not Connect The Con
View all ProForm Zt3 Treadmill manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
11. Hold the handrail assembly near the console assembly. Connect the wire harness extending from the console assembly to the wire harness extending from the handrail assembly. See the inset drawing in step 7. The connectors should slide together easily and snap into place. If they do not, turn one connector and try again. IF YOU DO NOT CONNECT THE CONNECTORS PROPERLY, THE CONSOLE MAY BECOME DAMAGED WHEN YOU TURN ON THE POWER. Set the Handrail Bracket (70) into the slot on the console assembly as you slide the ends of the Handrails (69, 71) onto the brackets on the Uprights (77, 78). Be careful not to pinch any wires. 11 Console Assembly Wire Harnesses Slot 69 Bracket 77 70 Handrail Assembly 71 78 Bracket 12. Start two 1/4" x 1 1/2" Bolts (3) with two 1/4" Washers (31) and two 1/4" Star Washers (11) into the Console Frame (92) and Handrail Bracket (not shown). Do not fully tighten the Bolts yet. Start four 1/4" x 1/2" Screws (6) with four 1/4" Star Washers (11) into the lower ends of the Handrails (69, 71). Press the lower end of the Handrails (69, 71) against the Uprights (77, 78) as you tighten the four 1/4" x 1/2" Screws (6). Then, tighten the 1/4" x 1 1/2" Bolts (3). 12 11 31 31 78 92 3 71 77 11 6 69 11 6 11