ProForm Zt3 Treadmill English Manual - Page 8

4. Raise the Uprights (77, 78) so that the Base (85) is flat on the floor and positioned as shown. See the far right drawing. Tie the wire tie in the Right Upright (78) around the end of the Upright Wire (74). Then, pull the other end of the wire tie until the Upright Wire is extending from the upper end of the Right Upright. Make sure that the end of the Upright Wire (74) does not fall into the Right Upright (78). 4 74 Wire Tie 77 5. See the left inset drawing. Identify the two Frame Spacers (79). Open the included packet 5 of grease, and apply grease to both sides of both Frame Spacers. Then, identify the outer side of each Frame Spacer. Hold a Frame Spacer (79) between the Right Upright (78) and the Lift Frame (65), with the outer side of the Frame Spacer facing the Right Upright. Attach the Right Upright to the Lift Frame with a 3/8" x 2 1/2" Bolt (1), a 3/8" Washer (10), and a 3/8" Nut (13); do not tighten the Bolt yet. 78 74 Large Hole Wire Tie 85 78 13 79 10 1 65 Grease 13 79 79 65 Outer Side 78 10 1 8