Pyle PD1000BA Instruction Manual - Page 6

SAFETY INSTRUCTIONS 1. Make sure that all connections are properly connected and the main volume is set to minimum level before turning ON the unit. 2. When more then one pair of speakers are used, (specially the main speaker output) make sure that the speakers used have the same wattage and impedance, otherwise the unit maybe damaged under high power or long term operation. 3. To avoid humming sounds and unwanted noise, make sure that all the wires are properly inserted. 4. For speaker cords, strip o the vinyl coating and twist the wire tip. Push down the pink jack or loosen the screw terminal, before inserting the wire tip, then fasten it and tighten the screw. Be careful not to let the wires stick out of the terminal otherwise this may cause a short circuit when wires of di erent terminal contact each other. 5. After the unit is turned ON, adjust the main volume to the desired level same with the bass and treble volume, etc. BASIC CONNECTION Connecting to a TV with Audio/Video cable • If the TV has an S-video input, connect the DVD player with an S-video cable. When using an S-video cable, do not connect the yellow video cable. Note: The volume adjusting only works when it's connected to a power ampli er. While it's connected to TV set without speakers, the volume cannot be adjusted on this device. You can only adjust the volume on the TV set. 10 www.PyleUSA.com Connecting to an Audio System Connecting to an Ampli er Equipment BASIC PLAYBACK Preparations • When you want to view a disc, turn on the TV and select the video input connected to the unit Basic Playback 1. Press POWER switch in the front panel to ON, the unit turns on and the TV screen will display the start logo. If a disc is already in the tray, it will begin to play once the power is ON. 2. Press OPEN/CLOSE to open the disc tray, place a disc on the disc tray. • There are two di erent disc sizes. Place the disc In the correct guide on the disc tray. If the disc is out of the guide, it may damage the disc and cause the unit to malfunction. • Do not place disc which is unplayable in this unit. 3. Press OPEN/CLOSE to close the disc tray, the playback will automatically start. • Some disc may not playback automatically, you can press PLAY button to start playback. 4. Some disc may start playback with a menu, use the cursor button on the remote controller to select menu options and press PLAY to start, or press digits to select a menu options directly. www.PyleUSA.com 11