Pyle PLMRB29B User Manual - Page 13

REMOTE CONTROL Remove Insulating Sheet The remote control comes with an insulating sheet attached to the underside of the remote control, as illustrated on the right. The remote control will not work until the insulating sheet is removed. Replace Lithium Battery Cell 1. When the lithium cell battery becomes weak, replace it as illustrated on the right. 2. Press and hold the movable block in the direction indicated by arrow 1. At the same time, pull the cell holder out of the remote control in the direction indicated by arrow 2. 3. Replace the old cell with a new one, making sure the (+) polarity is facing upward. 4. Re-insert the cell holder into the remote control. - Cell leakage may cause damage to the remote control. - Do not throw cells into as this may cause an explosion. - Keep battery cells out of reach of children. Remote Control Operation Position the emitting window of the remote control toward the sensor window of the unit. • The operation angle for front panel remote control reception is about 30 degrees. • The distance between the emitting window of the remote control and the sensor window of the unit should remain less 5 meters. Button Names and Locations 1. (Power on/off) button 2. VOL+/VOL-(volume increase/decrease) button 3. Band button, (answer call) button 4. button: Tune down, seek down; Track down, fast reverse 5. SEL(selection) button 6. button: Tune up, seek up; Track up, fast forward 7. Mute button, DEL(Delete) button 8. CLK(clock setting) button, (end call) button 9. button, preset station 1 button, keypad 1 10. INT(intro) button, preset station 2 button, keypad 2 11. RPT(repeat) button, preset station 3 button, keypad 3 12. RDM (random), preset station 4 button, keypad 4 13. -10(previous 10 tracks), preset station 5 button, keypad 5 14. +10(next 10 tracks), preset station 6 button, keypad 6 15. ST (stereo) button, keypad 7 16. LOUD(loudness) button, keypad 8 17. AMS (automatic music search) button, keypad 9 18. MODE button, keypad * 19. EQ(Equalizer) button, keypad 0 20. LOC (local)/DX button, keypad # Note: When using the remote control for the first time, you must pull out the protective plastic tab from the battery compartment found on the back of the remote control. - 12 -