RCA RDW3208 English Manual - Page 19

1．Screw the faucet adapter onto (or into) the faucet tap. Check for leaks (use Teflon tape to eliminate if necessary). 2. Connect the six-sided connection of the drain hose to the drain port connection on the back of the dishwasher cabinet. Do not over-tighten (to avoid damage t o threads). 3.Connect the star-shaped connection of the inlet hose to the inlet port on the back of the dishwasher cabinet. Do not over-tighten (to avoid damage to threads). 4.Connect the circular connection of the drain hose onto the longer (bottom) male connection on the quick co n nect . 5.Connect the circular connection of the inlet hose onto the short er (top) male connection on the quick co n nect . 6.Attach the quick connect ont o the faucet adapter, by pulling dow n the outer locking collar on the quick connect , while pushing the quick connect upward onto the f aucet adapter. 7.When the quick connect snaps onto the f aucet adapter, release the locking collar. Veri fy the connection is secure. 8. Slowly open the hot water line and check for any sign of water leaks at all hose connec tions. If leaks are located, immediately close the water supply and repair the hose connections. Important 1. Once you open the w ater supply line, (even if it is closed immediately thereafter), the inlet hose will be pressurized. 2. To relieve water pressure from inside the inlet hose, (m ake sure the water line (faucet) is closed): press and hold the red pressure relief button on the quick connect until the flow of water stops. WARNING FAILURE TO RELIEVE WATER PRESSURE, BEFORE DISCONNECTING THE Q U I CK -C O NN E CT FROM THE FAUCET, WILL RESULT IN BACK-PRESSURE OVER-SPRAY. THE TEMPERATURE OF INCOMINGWATER CAN BE VERY HOT, AND BACK-PRESSURE OVER-SPRAY COULD CAUSE SEVERE BURNS AND/OR SCALDING. DANGER DO NOT LET CHILDREN DISCONNECT THE DISHWASHER; CLOSE SUPERVISION OF ALWAYS IMPORTANT AROUND APPLIANCES. CHILDREN IS NOTE: Hard water conditions will adversely affect the washing performance of your dishwasher. Hard water conditions will also contribute to 'lime' (white fi lm su bstance) d eposits and/or 'scaling' on the stainless steel surface of the dishwasher tub and heater element , located in the sump underneath the removable fi lter screen. To assist in minimizi ng these conditions, it is recommended to periodicall y operate/rinse the inside of the dishwasher (empty) using 1 cup of white vinegar at least once a week. Disconnecting your Dishwasher 1.Shut off the wat er supply at the faucet. 2.Disconnect the power supply cord The following things should be checked before starting the dishwasher. 1 The dishwasher is level and fixed properly 2 The inlet valve is open 3 There is a leakage at the connections of the conducts 4 The wires are tightly connected 5 The power is switched on 6 The inlet and drain hoses are knotted 7 All packing materials and printings should be taken out from the dishwasher After installation, please make sure to keep this manual. The content of this manual is ver y helpf ul to the users. 16