Rane AC 23S Operation Manual - Page 6
Rear Panel: Stereo 2-way Connections - ac 23 23s
View all Rane AC 23S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
REAR PANEL: STEREO 2-WAY CONNECTIONS 2 6 5 7 6 Stereo 2-way connection labels are in this row Right Input 1 Left Input 100-240 V COMMERCIAL AUDIO 50/60 Hz 7 WATTS EQUIPMENT 24TJ AC 23S MADE IN U.S.A. RANE CORP. PIN 2: POSITIVE PIN 3: NEGATIVE PIN 1: CHASSIS GND HIGH OUT 3W: MID OUT 2W: LOW 3W: LOW OUT 2W: OMIT R ACN 001 345 482 This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. HIGH OUT 4W: OMIT 5W: HIGH MID OUT LOW OUT CHANNEL 2 IN MONO: OMIT STEREO 3W / 2W SET TO 5W CHANNEL 2 STEREO 3W 2W STEREO CHANNEL 1 MONO STEREO 4W 5W 3W 2W MONO: SET SWITCHES AS SHOWN HIGH OUT 3W: MID OUT 3W: LOW OUT 2W: LOW 2W: OMIT MONO: OMIT MID OUT SUB OUT 8 34 34 CHANNEL 1 IN MONO 4W / 5W IN High Amp High Amp Low Amp Low Amp Observe the labels above the Inputs and Outputs for Stereo operation. 1 CHANNEL 1 INPUT: Plug the left output of the mixer, equalizer or other signal source to this Input. Pin 2 is "hot" per AES standards. 2 CHANNEL 2 INPUT: Plug the right output of the mixer, equalizer or other signal source to this Input. 3 HIGH FREQUENCY OUTPUTS: Connect the CHANNEL 1 HIGH OUT to the left channel input of the high frequency amp, and the CHANNEL 2 HIGH OUT to the right channel input of the high frequency amp. 4 LOW FREQUENCY OUTPUTS: Connect the CHANNEL 1 "2W-LOW" Output to the left channel input of the low frequency amplifier, and the CHANNEL 2 "2W-LOW" Output to the right channel input of the low amplifier. If you need a summed Mono Low Ouput, see 'Monoing the Low Outputs' on page Manual-15. 5 STEREO / MONO switch: Set this switch to the STEREO "out" position. 6 STEREO 2‑Way / 3‑Way switches: Slide the switches to the 2-Way position. This switch removes the Low frequency crossover from the signal path. Low frequencies are now routed to the Mid frequency Output. Note: The Low frequency outputs are still active and may be used as additional Low outputs. 7 MONO 4‑Way / 5‑Way switch: Set this switch to the 5-Way position for stereo operation. 8 Universal Voltage Input: via a miniature IEC 60320 C6 appliance inlet. This mates with an IEC 60320 C5 line cord (USA domestic). Do not lift the ground connection! Manual-3