Reebok Rel 8 Elliptical English Manual - Page 6

1. Identify the Rear Stabilizer (59), which has Wheels (45) attached to it. 1 Attach the Rear Stabilizer (59) to the rear of the Frame (1) with the two Rear Stabilizer Bolts (60) and two M10 Nylon Locknuts (26). Make sure that the Rear 26 Stabilizer is turned so the Wheels (45) are not touching the floor. 1 2. Attach the Front Stabilizer (14) to the front of the 2 Frame (1) with the two Front Stabilizer Bolts (86) and two M10 Nylon Locknuts (26). 14 86 26 59 45 60 26 3. Slide an M8 Split Washer (58) and an M8 Washer (33) onto an Incline Axle Screw (30). Tighten the Incline Axle Screw into one end of an Incline Axle (29). Next, apply a small amount of the included grease to the Incline Axle. Align the indicated tubes on the Incline Ramp (5) with the tubes on the Base (1). Make sure that the Incline Ramp is turned so the V-shaped grooves are on top. Insert the Incline Axle (29) through the Incline Ramp and the Base. Note: It may be helpful to tap the Incline Axle with a rubber mallet to insert it. Slide an M8 Split Washer (58) and an M8 Washer (33) onto another Incline Axle Screw (30). Tighten the Incline Axle Screw into the open end of the Incline Axle (29). 4. Slide an M8 Split Washer (58) and an M8 Washer (33) onto an Incline Axle Screw (30). Tighten the Incline Axle Screw into one end of the other Incline Axle (29). Next, apply a small amount of grease to the Incline Axle. Raise the Incline Ramp (5). Insert the Incline Axle (29) through one side of the Incline Ramp, through a 56mm Spacer (22), through the end of the motor screw, through another 56mm Spacer (22), and then through the other side of the Incline Ramp. Slide an M8 Split Washer (58) and an M8 Washer (33) onto another Incline Axle Screw (30). Tighten the Incline Axle Screw into the open end of the Incline Axle (29). 6 1 26 3 V-shaped Groove 5 58 33 Grease 29 33 58 30 Tubes 30 4 1 Tubes 58 33 22 30 29 33 58 30 Motor Screw 5 Grease