Ricoh 002292MIU User Guide - Page 311

Network Installation Using Internet Services Using Web Image Monitor Type 103 Introduction Web Image Monitor Type 103 uses the embedded HTTP Server on the Type 103 to allow communication with the Type 103 if you have a Web Browser with access to the Internet or Intranet. By entering the IP Address of the Type 103 as the URL (Universal Resource Locator) in the Browser, direct access to the Type 103 is available. NOTE: Microsoft Internet Explorer version 4.x or later should be used. Other browsers may work, but could produce unexpected results. Many of the selections and settings needed to install Type 103 on a network can be made using Internet Services, eliminating steps that would otherwise need to be performed at the Type 103 Control Panel. Many of the features available within Internet Services will require an admin user name and password. A user will only be prompted for an admin name and password once in a single browser session. Before the Internet Services feature can be used for installing Type 103 on a network it must be enabled. There are two stages required to enable Internet Services: ¾ Network Communication Setup This requires the Type 103 to be setup for Internet Services. ¾ Enable Internet Services ¾ Make settings to the appropriate network NOTE: When making more than one configuration change please complete all the changes in one go and then carry out a reboot. Administrator Guide Page 3-3