Ricoh 002292MIU User Guide - Page 320
LPR/LPD, Installation Procedure, Con the Type 103
![]() |
UPC - 026649124723
View all Ricoh 002292MIU manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 320 highlights
Network Installation Using Internet Services LPR/LPD Use these instructions to enable or disable LPR/LPD using Web Image Monitor Type 103. Installation Procedure There are two stages required to install the device on a LPR/LPD network using Web Image Monitor Type 103: ¾ Configure the Type 103 This procedure explains how to use Web Image Monitor Type 103 to configure the device. ¾ Test Print A print job should be submitted to ensure the device has been installed and configured correctly. Configure the Type 103 To complete the installation of the device, perform these steps: 1 ¾ Enable Web Image Monitor Type 103 (see "Enabling Internet Services" on page 3-5). 2 ¾ At the Web Image Monitor Type 103 Home Page for the Type 103, select the [Network Settings] tab. 3 ¾ In the Network Settings, select [Raw TCP/IP, LPR, IPP]. 4 ¾ Select the checkbox to enable LPR/LPD. Enter the [Port Number]. NOTE: While you can change the port number at which the Type 103 will accept LPR print jobs, it is recommended that you do this ONLY with extreme caution as most LPR spoolers are set to send print jobs to the default port number, 515. Page 3-12 Administrator Guide
![](/manual_guide/products/ricoh-002292miu-user-guide-9b618ab/320.png)