Ricoh 002292MIU User Guide - Page 316
TCP/IP, Installation Procedure, Con the Type 103
![]() |
UPC - 026649124723
View all Ricoh 002292MIU manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 316 highlights
Network Installation Using Internet Services TCP/IP Use these instructions to install the device on a TCP/IP network using Web Image Monitor Type 103. Installation Procedure There are two stages required to install the device on a TCP/IP network using Web Image Monitor Type 103: ¾ Configure the Type 103 This procedure explains how to use Web Image Monitor Type 103 to configure the device. ¾ Test Print A print job should be submitted to ensure the device has been installed and configured correctly. Configure the Type 103 NOTE: The TCP/IP settings for the device will have been setup when completing the Enabling Web Image Monitor Type 103 section. To complete the installation of the device, perform these steps: 1 ¾ Enable Web Image Monitor Type 103 (see "Enabling Internet Services" on page 3-5). 2 ¾ At the Web Image Monitor Type 103 Home Page for the Type 103, select the [Network Settings] tab. 3 ¾ In the [TCP/IP] field, Ethernet will be the default setting. Select the checkbox to enable TCP/IP. Choose the [IP Address Assignment Method] required. NOTE: DHCP automatically assigns IP addresses and is the default setting. If the IP Address needs to be edited but is unavailable, choose Static in [IP Address Assignment Method] and continue. Enter the [IP Address]. Enter the [Subnet Mask]. Enter the [Gateway Address]. Page 3-8 Administrator Guide
![](/manual_guide/products/ricoh-002292miu-user-guide-9b618ab/316.png)