Ricoh 8100DN Hardware Guide - Page 128

9. Removing Misfed Paper Removing Misfed Paper An error message appears if a paper misfeed occurs. The error message gives the location of the misfeed. R CAUTION: • The inside of the machine becomes very hot. Do not touch the parts with a "v" label (means hot surface). Touching a part with a "v" label (means hot surface) could result in a burn. R CAUTION: • When pulling the paper tray out, be careful not to pull it strongly. If you do, the tray might fall and cause an injury. Important ❒ Misfed paper may be covered in toner. Be careful not to get toner on your hands or clothes. ❒ Toner on prints made after removing misfed paper may be loose (inadequately fused). Make a few test prints until smudges no longer appear. ❒ Do not forcefully remove misfed paper, it will tear. Torn pieces remaining inside the printer will cause further misfeeds and possibly damage the printer. ❒ More than one misfed area might be indicated. In this case, check every applicable area. See the following charts shown in the illustration. D C BZ A Y U R AQV050S ❒ If paper continues to misfeed, check the following points. • Confirm that the setting of the paper size dial matches the size and feed direction of the paper loaded in the paper tray. • Confirm that the toner cartridge is set correctly. ❒ If paper misfeeds still occur, contact your sales or service representative. ❒ Do not leave any torn paper scraps within the printer. 117