Ricoh 8200DN Administration Guide - Page 16

2 SafeCom Go Ricoh 2.2.2 Legacy devices Type B SafeCom Ricoh SD ID Kit mounted on Type B device. Install the VM Card (SD card) that was supplied by Ricoh: 1. Press the operation switch to turn off power. Wait for the On indicator to go off (stop blinking) and then turn off the main power switch. Disconnect the power cable. 2. Locate the printer's SD card slots (typically located at the rear of the printer near the RJ-45 network socket). On some printers you have to remove a plastic cover first. 3. Insert the SD card labeled VM Card in SD card slot 2 or 3. Install the supplied SafeCom Ricoh SD ID Kit: 4. Insert the SafeCom Ricoh SD Card into an available SD slot. Insert the SafeCom Ricoh SD ID Kit in an available interface board slot. 5. Connect the white female connector at the end of the cable to the corresponding male 8-pin connector on the SafeCom Ricoh SD Card. It only fits in one way. 6. Connect the external power supply (5V, 1.0A) to the SafeCom Ricoh SD ID Kit. Install MFP cable and/or SafeCom ID Device: 7. Connect the SafeCom MFP cable's white 4-pin connector to the Ricoh MFP's FIH connector. The FIH connector is typically located on the right side of the MFP behind a plastic cover. Connect the blue PS/2 connector to the serial port of the SafeCom Ricoh SD ID Kit. If a serial SafeCom ID Device was supplied connect it to the black female connector of the SafeCom MFP cable. If there is no MFP cable then connect the ID Device directly to the serial port of the SafeCom Ricoh SD ID Kit. If the Type C MFP has a USB port (extra Ricoh accessory) a USB SafeCom ID device can be used. However, the SafeCom Ricoh SD ID Kit still needs to be installed to have copy control. Reconnect power: 8. Connect the power cable. Turn on the main power switch. Press the operation switch to turn on power. 9. The printer's control panel displays Please wait... for 30 seconds. Proceed to section 2.3. D60703-17 16