Ricoh AP610i Setup Guide - Page 43
Attaching Memory Unit Type C 256MB, SDRAM Module
UPC - 026649024917
View all Ricoh AP610i manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 43 highlights
Installing Options Attaching Memory Unit Type C 256MB (SDRAM Module) • Do not touch the inside of the controller board compartment. Doing so may cause a malfunction or a burn. ❒ Before touching the memory unit, touch something metal to discharge any static electricity. Static electricity can damage the memory unit. ❒ Do not subject the memory unit to physical shocks. ❒ If a printer hard disk is already installed, temporarily remove it and insert the memory unit. Reinstall the printer hard disk after inserting the memory unit. ❒ Before using the new memory unit, you must make settings in the printer driv- er. A Turn off the power of the printer, and then unplug the printer's power ca- ble and the interface cable. B If the duplex unit is attached, push down the lever on right side ( ) and pull out the duplex unit until it stops ( ). If the duplex unit is not attached, go to the following steps. C Remove the two screws holding the controller board in place. ❒ Use a coin or similar object if the screws do not turn easily. 43