Ricoh AP610i Setup Guide - Page 62
then pull out the duplex unit until it stops
UPC - 026649024917
View all Ricoh AP610i manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 62 highlights
Installing Options • Antenna Cap B Turn off the power of the printer, and then unplug the printer's power ca- ble and the interface cable. C If the duplex unit is attached, push down the lever on right side ( ) and then pull out the duplex unit until it stops ( ). If the duplex unit is not attached, go to the following steps. D Remove the two screws holding the controller board in place. ❒ Use a coin or similar object if the screws do not turn easily. ❒ These screws are used again in fastening the controller board. 62
Installing Options
62
•
Antenna Cap
B
Turn off the power of the printer, and then unplug the printer's power ca-
ble and the interface cable.
C
If the duplex unit is attached, push down the lever on right side (
) and
then pull out the duplex unit until it stops (
).
If the duplex unit is not attached, go to the following steps.
D
Remove the two screws holding the controller board in place.
❒
Use a coin or similar object if the screws do not turn easily.
❒
These screws are used again in fastening the controller board.