Ricoh AP610i Setup Guide - Page 53
Align the power cable to the left side groove of the duplex unit, and then
UPC - 026649024917
View all Ricoh AP610i manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 53 highlights
Installing Options M Fasten the controller board to the printer with the two screws. N Align the power cable to the left side groove of the duplex unit, and then slide the duplex unit in until it is connected to the printer. If the duplex unit is not attached, this step is not necessary. ❒ After finishing installation, you can check the 1394 interface unit is properly installed: Print the configuration page from the "List/Test Print" menu. If it is installed properly, you will see "IEEE1394" for "Controller Option". ❒ You need to make settings with the control panel before using the 1394 interface unit. For more information, see p.91 "IEEE 1394 Configuration". ❒ If the 1394 interface unit is not installed properly, repeat the procedure from the start. If you cannot install it properly even after reinstallation, contact your sales or service representative. For printing the configuration page, see p.32 "Test Printing". 53