Ricoh AP610i Setup Guide - Page 67
If the Bluetooth interface unit is not installed properly, repeat the procedure
UPC - 026649024917
View all Ricoh AP610i manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 67 highlights
Installing Options Q Align the power cable to the left side groove of the duplex unit, and then slide the duplex unit in until it is connected to the printer. If the duplex unit is not attached, this step is not necessary. ❒ After finishing installation, you can check the Bluetooth interface unit is properly installed: Print the configuration page from the "List/Test Print" menu. If it is installed properly, you will see "Bluetooth" for "Controller Option". ❒ If the Bluetooth interface unit is not installed properly, repeat the procedure from the start. If you cannot install it properly even after reinstallation, contact your sales or service representative. For printing the configuration page, see p.32 "Test Printing". 67
Installing Options
67
Q
Align the power cable to the left side groove of the duplex unit, and then
slide the duplex unit in until it is connected to the printer.
If the duplex unit is not attached, this step is not necessary.
❒
After finishing installation, you can check the Bluetooth interface unit is
properly installed: Print the configuration page from the “List/Test Print”
menu. If it is installed properly, you will see “Bluetooth” for “Controller Op-
tion”.
❒
If the Bluetooth interface unit is not installed properly, repeat the procedure
from the start. If you cannot install it properly even after reinstallation, con-
tact your sales or service representative.
For printing the configuration page, see
p.32 “
Test Printing
”
.