Ricoh FW770 Operating Instructions - Page 253

Settings You Can Change with User Tools • Semi-synchro Cut Original Scanning Mode(+18): Selects whether the roll paper cut key must be pressed at the appropriate time when the trailing edge of the original passes the Semi-synchro cut mark, or whether the original must be inserted again after the original is scanned and the length is measured. Note ❒ 0: Pressing the roll paper cut key, 1: Inserting the original again ❒ Default: 0 • Semi-synchro Cut Length Adjustment(+19): Adjust the cut length in the semi-synchro cut mode.The setting can be changed from -25 to 25 by 1mm steps. 3 Note ❒ Default: 0 • Paper Length Up/Down Setting(+20): Select if the paper length is count down or up when the preset cut key is pressed. Note ❒ 0: Down count, 1: Up count ❒ Default: 0 • Paper Length Up/Down Speed Setting(+21) :The copier can scroll through the preset lengths forward or backward, and at different speeds. There are many sets of sizes from which to choose. Note ❒ 0: 0.10 seconds, 1: 0.5 seconds, 2: 0.25 seconds, 3: 0.05 seconds, 4: 0.02 sec- onds, 5: 0.01 seconds ❒ Default: 0 • Fixed Paper Size Pattern Setting(+22): Select the fixed paper size pattern chosen when the "Preset Cut" key is press. For details about this setting, contact your service representative. • Optional Paper Size Setting(+23 ~ +32): Up to 10 different paper size can be stored from 23 to 32.For details about this setting, contact your service representative. • Auto Off Function setting(+33): This setting allows you to enable or disable the Auto Off function. Note ❒ 0: Disable, 1: Enable ❒ Default: 1 • Darker Image Density(+37): Sets the range of the ID density control to give finer control over darker images. - ID level 1 to 7-Darker image density and low contrast settings -ID level 8 to 14-cannot be shifted 43