Ricoh FW770 Operating Instructions - Page 336

Copy Settings Partial Copying The Partial Copy function copies only a part of an original. You need to enter start and end points in the feed direction of the original . a Synchro Cut Mode 3 b original Bypass Table Preset/Variable Cut Mode Note ❒ You cannot use the Partial Copying function when using the Rear Table. ❒ You cannot use the Partial Copying function for originals shorter than 255mm. ❒ If you set the start point within 155 mm of the leading edge of the original, the copier will regard the leading edge as the start point. ❒ The minimum available space between the start point and the end point is 30 mm. ❒ If you do not set the end point after setting the start point (a), the copier will regard the trailing edge of the original as the end point (b). ❒ If you set the start point within 40mm of the trailing edge of the original, the copier will cancel the copying and eject the original. ❒ If you set the end point within 40mm of the trailing edge of the original, the copier will regard the trailing edge as the end point. ❒ In the Synchro Cutting function, the copier will cut the paper in a length from the start point to the end point. ❒ When the Partial Copying function is selected, the copier will reset the settings for the trailing edge margin, the leading edge margin in the Synchro Cutting function, and the Repeated Copying function. A Hold down the {Function Select} key for 3 seconds or more. 34