Ridgid JP0610 Owners Manual - Page 34
Accessories, Troubleshooting - home depot
View all Ridgid JP0610 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 34 highlights
ACCESSORIES Look for these accessories at The Home Depot: �Jointer Knives...AC8600 Push Blocks ...AC8601 Dust Collection Kit...AC8602 WARNING: Attachments and accessories available for use with this tool are listed above. Do not use any attachments or accessories not recommended by the manufacturer of this tool. The use of attachments or accessories not recommended can result in serious personal injury. TROUBLESHOOTING Problem Cause Solution Motor will not run 1. Defective On-Off switch Defective capacitor Defective motor 2. Low line voltage 3. Belt tension too high 1. Consult an Authorized Service Center. Any attempt to repair this electrical device may create a hazard unless repair is done by a qualified service technician. Repair service is available at your nearest Authorized Service Center. 2. See "Troubleshooting (Motor)" section. 3. Adjust belt tension. Wood strikes outfeed table 1. Outfeed table improperly adjusted above 1. Readjust table, see "Outfeed Table Adjustment" after passing over cutter cutter knives section. head Ripples on planed surface Kickbacks 1. One knife set higher than other 2. Feeding wood too fast 3. Cutting knives are set too high above outfeed table, or they are not leveled with outfeed table 1. Readjust knives, see "Maintenance" section. 2. Feed wood slower. 3. Readjust knives, see "Maintenance" section. Planed surface not straight 1. Outfeed table out of adjustment 1. Readjust table, see "Outfeed Table Adjustment" section. Excessive gouging at end 1. Outfeed table set too low of cut 1. Readjust table, see "Outfeed Table Adjustment" section. 45°, 90° and 135° cuts inaccurate 1. Fence stops not adjusted properly 2. Fence bottom not even with outfeed table due to wood chips under fence 1. Readjust fence stops, see "Alignment" section. 2. Clean wood chips from underside of fence. Infeed or outfeed table 1. Loose gib loose 1. Tighten gibs. Cutter guard does not function properly 1. Return spring broken, or spring needs adjustment 34 1. Consult an Authorized Service Center immediately if broken. 2. Adjust spring.