Ridgid RP 330-C Owners Manual - Page 13
Troubleshooting
View all Ridgid RP 330-C manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
RP 330 Pressing Tool Troubleshooting SYMPTOM POSSIBLE REASONS SOLUTION Tool will not turn ON when ON/OFF button on display panel is pressed. Electric cord damaged. Battery is completely discharged or battery has failed or power cord not properly inserted into outlet. Battery not properly inserted into handle of tool. Tool turns OFF either when trigger is depressed or in the middle of a press cycle. Red LED glows. Battery is too low. Tool or battery is too cold or too hot. Inspect the cord and replace if necessary. Insert fully charged battery/recharge dead battery or unplug and replug power cord. Check to assure battery is fully inserted. Insert fully charged battery/recharge dead battery. Bring tool and battery to correct operating range between 15°F (-10°C) to 122°F (50°C) by allowing the tool to sit in a conditioned room. NOTE! Fitting must be repressed if tool stops in the middle of a press cycle. Failure to do so may result in a leaking fitting. Yellow LED blinks repeatedly as long as tool is turned ON and tool functions properly. Scheduled maintenance/recalibration is required after 30,000 presses. Contact Ridge Tool Company, Technical Service Department at (800) 519-3456 for nearest Authorized Service outlet. Yellow LED glows continuously and tool will not begin press cycle when trigger switch is depressed. Scheduled maintenance/recalibration is mandatory after 32,000 presses. Tool is "locked" and will not function until tool is serviced. Contact Ridge Tool Company, Technical Service Department at (800) 519-3456 for nearest Authorized Service outlet. Red LED blinks repeatedly and tool will not begin press cycle when trigger switch is depressed. Accessory mounting pin not fully closed. Insert accessory mounting pin to the fully closed position. Yellow LED glows when Tool malfunction detected. tool is turned ON. Unplug and replug power cord or remove and reinsert fully charged battery. Be sure to repress fitting. If LED's continue to glow, contact Ridge Tool Company, Technical Service Department at (800) 519-3456 for nearest Authorized Service outlet. Jaws are locked onto fitting. Press was not successfully completed. Push pressure release valve to remove jaws from fitting. Inspect and repress fitting. The pressed connections produced are not complete. Used wrong jaw set for the tube size or material. The tool was not square to the tube. Jaw contour was not aligned with the fitting contour. Tool is in need of repair. Install the correct jaw set. Redo the joint with new fitting and new tube. Make sure that the tool is square to the tube. Redo the joint with new tube and new fitting. Make sure the jaw contour is aligned with the fitting contour. Contact Ridge Tool Company, Technical Service Department at (800) 519-3456 for nearest Authorized Service outlet. Ridge Tool Company 11