Ryobi DP102L English Manual - Page 15

ASSEMBLY installing chuck, head assembly, and feed handles See Figures 9 - 11.  Place the head assembly upside down on a level, flat surface.  Position chuck on spindle. Chuck should be fully opened to avoid damaging jaws.  Using a piece of scrap wood to protect the chuck, firmly tap the chuck into place using a mallet or hammer.  Position the head assembly onto the column with the chuck positioned over the table. Note: This tool is heavy. Get help when needed. feed handle Fig. 11 chuck spindle head assembly scrap wood  Slide the head assembly down as far as it will go. Align the table assembly with the base and then tighten the two head set screws with the hex key.  Attach the three feed handles by screwing them into the threaded holes in the hub. Installing/changing worklight bulb See Figure 12. The integrated worklight can be used to help illuminate the work area. The worklight requires a 15-watt, 120-volt, ­candelabra-base bulb (bulb not included). To install, insert the bulb into the worklight receptacle and twist clockwise to secure. Fig. 9 head assembly set screws Fig. 10 15 bulb Fig. 12