Ryobi DP102L English Manual - Page 16
Installing/changing Laser Batteries, Warning, Mounting The Drill Press - motor size
View all Ryobi DP102L manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
assembly Installing/changing laser batteries See Figure 13. Lift head assembly cover from front to open. Remove cover from battery compartment and install two AA batteries according to the polarity indicated in the compartment. Reinstall the battery compartment cover. Close head assembly cover. battery compartment cover AA Batteries WARNING: Use of controls or adjustments or performance of procedures other than those specified herein could result in hazardous radiation exposure. Mounting the Drill press See Figure 14. If the drill press is to be used in a permanent location, secure it to a workbench or other stable surface. If the drill press is to be used as a portable tool, fasten it permanently to a mounting board that can easily be clamped to a workbench or other stable surface. The mounting board should be of sufficient size to avoid tipping while drill press is in use. Any good grade plywood or chipboard with a 3/4 in. thickness is recommended. ■ Mark holes on surface where drill press is to be mounted using holes in drill press base as a template for hole pattern. ■ Drill holes through mounting surface. ■ Place drill press on mounting surface, aligning holes in the base with holes drilled in the mounting surface. ■ Insert bolts (not included) and tighten securely with lock washers and hex nuts (not included). If lag bolts are used, make sure they are long enough to go through holes in drill press base and material the drill press is being mounted to. If machine bolts are used, make sure bolts are long enough to go through holes in drill press, the material being mounted to, and the lock washers and hex nuts. Note: All bolts should be inserted from the top. Install the lock washers and hex nuts from the underside of the workbench. Once the drill press is securely mounted on a sturdy surface: Check for vibration when the motor is switched ON. Adjust and retighten the mounting hardware as necessary. Check the table assembly to assure smooth movement up and down the column. Check to assure that the spindle shaft moves smoothly. head assembly DANGER / DANGER / PELIGRO DANGER / DANGER / PELIGRO Fig. 13 mounting bolts base Fig. 14 16