Ryobi P4002 Operation Manual - Page 8

FEATURES PRODUCT SPECIFICATIONS Cable Diameter 0.25 in. Cable Length 25 ft. Power Source 18 Volt DC/120 V, AC only, 60 Hz Minimum Pipe Size (diameter 0.75 in. Maximum Pipe Size (diameter 2 in. ASSEMBLY WARNING: Do not use this product if it is not completely assembled or if any parts appear to be missing or damaged. Use of a product that is not properly and completely assembled or with damaged or missing parts could result in serious personal injury. WARNING: Do not attempt to modify this product or create accessories or attachments not recommended for use with this product. Any such alteration or modification is misuse and could result in a hazardous condition leading to possible serious personal injury. If any parts are damaged or missing, please call 1-800-525-2579 for assistance. OPERATION WARNING: Do not allow familiarity with this product to make you careless. Remember that a careless fraction of a second is sufficient to inflict serious injury. WARNING: Always remove battery pack or unplug power cord from your product when you are assembling parts, making adjustments, cleaning, or when not in use. Removing battery pack or unplugging power cord will prevent accidental starting that could cause serious personal injury. WARNING: Always wear eye protection with side shields marked to comply with ANSI Z87.1. Failure to do so could result in objects being thrown into your eyes and other possible serious injuries. WARNING: Do not use any attachments or accessories not recommended by the manufacturer of this product. The use of attachments or accessories not recommended can result in serious personal injury. APPLICATIONS You may use this product for the purposes listed below:  Clearing obstructions from sinks and bathtubs. NOTICE: This product is designed to be powered by either a RYOBI™ One+™ 18V battery pack (DC mode) or by electric power (AC mode). Either power source can be used by installing an approved battery pack or power cord into the product as described in this manual. INSTALLING/REMOVING BATTERY PACK See Figure 1, page 13.  Lock the switch trigger by placing the direction of rotation selector in center lock position.  Insert the battery pack into the battery port.  Make sure the latches on each side of the battery pack snap in place and that battery pack is secured in the product before beginning operation.  Depress the latches to remove the battery pack. For complete charging instructions, see the operator's manuals for your battery pack and charger. 8 - English