Ryobi TS1345L User Manual - Page 18
Warning, Danger, Aligning The Laser Guide Line
View all Ryobi TS1345L manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
ASSEMBLY Tighten blade bolt securely. Replace the lower blade guard and blade bolt cover. Securely tighten the blade bolt cover screw. Raise and lower the saw head and ensure that the lower blade guard operates properly. WARNING: Make sure the spindle lock button is not engaged before reconnecting saw into power source. Never engage spindle lock button when blade is rotating. LASER GUIDE SWITCH DANGER: Laser radiation. Avoid direct eye contact with light source. WARNING: Use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous radiation exposure. ALIGNING THE LASER GUIDE LINE See Figure 17. Lock the switch by installing a padlock (not included) through the hole in the switch trigger and closing the shackle. Draw a line on the workpiece. When the laser guide switch is turned on it will generate a red line on the work surface. This line will let you see your mark and the laser guide line at the same time, and will assist you in lining up the mark for more accurate cutting of the workpiece. Align the laser line and the mark with the blade at the uppermost position. Once both lines are in alignment, do not move the workpiece. Remove the padlock then plug the saw into the power source. Make several practice cuts on different styles and thickness of material. Repeat the steps above as necessary. Removing Your Mark: Position the laser line near the left edge of your mark on the work surface in order to remove the mark. To Cut Your Mark: Position the laser line near or over your mark on the work surface in order to cut the mark. To Leave Your Mark: Position the laser line near the right edge of your mark on the work surface in order to leave the mark. After you have become familiar with using the laser guide, you will be able to remove, cut, or leave your mark on the work surface. Practice will teach you the correct position for aligning the laser line with your mark. 18 − English • To reduce the risk of injury, user must read and understand the operator's manual before using the miter saw. • Wear eye protection. • Keep hands out of path of saw blade. • Do not operate saw without guards in place. • Do not perform any operation freehand. • Never reach around the saw blade. • Turn off tool and wait for saw blade to stop before raising saw arm, moving workpiece, or changing settings. • Disconnect the saw from the power source before changing blade or servicing. Complies with 21 CFR RYLD Parts 1040.10 & 1040.11 LASER RADIATION AVOID DIRECT EYE EXPOSURE CLASS IIIa LASER PRODUCT MAXIMUM OUTPUT: