Ryobi TSS120L User Manual - Page 13
Warning, Mounting Holes, Dust Bag - saw
View all Ryobi TSS120L manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
ASSEMBLY WARNING: Always make sure the compound miter saw is securely mounted to a workbench or an approved workstand. Failure to heed this warning can result in serious personal injury. Mounting Holes See Figure 8. If not using a stand, the saw should be mounted to a firm supporting surface such as a workbench. Four bolt holes have been provided in the saw base for this purpose. Each of the four mounting holes should be bolted securely using 1/4 in. machine bolts, lock washers, and hex nuts (not included). Bolts should be of sufficient length to accommodate the saw base, lock washers, hex nuts, and the thickness of the workbench. Tighten all four bolts securely. The hole pattern for mounting to a workbench is shown in figure 8. Carefully check the workbench after mounting to make sure that no movement can occur during use. If any tipping, sliding, or walking is noted, secure the workbench to the floor before operating. DUST BAG See Figure 9. A dust bag is provided for use on this miter saw. It fits over the exhaust port on the upper blade guard. To install, squeeze the two metal clips to open the mouth of the bag and slide it on the exhaust port. Release the clips. The metal ring in the bag should lock in between the grooves on the exhaust port. To remove the dust bag for emptying, simply reverse the above procedure. dust bag exhaust port 45 Fig. 9 trace holes at these locations for hole patTern 45 31.6 30 22.5 22.5 30 31.6 15 0 15 BASE 45 trace holes at these locations for hole patTern mounting surface Fig. 8 13