Ryobi TSS120L User Manual - Page 16

ASSEMBLY Note: Many of the illustrations in this manual show only portions of the compound miter saw. This is intentional so that we can clearly show points being made in the illustrations. Never operate the saw without all guards securely in place and in good operating condition. SQUARING THE MITER TABLE TO THE FENCE See Figures 13 - 16.  Remove the battery pack from the tool.  Push down on the saw arm and pull out the lock pin to release the saw arm.  Raise the saw arm.  Lift the miter lock lever.  Rotate the miter table until the pointer aligns with zero on the miter scale.  Push the miter lock lever down to lock the miter table.  Lay a square flat on the miter table. Place one leg of the square against the fence. Place the other leg of the square beside the throat plate in the miter table. The edge of the square and the throat plate in the miter table should be parallel as shown in figure 13.  If the edge of the square and the throat plate in the miter table are not parallel as shown in figures 14 and 15, adjustments are needed.  Using the blade wrench provided, loosen the socket head screws securing the fence. Adjust the fence left or right until the square and throat plate are parallel.  Retighten the screws securely and recheck the fence-totable alignment. MITER FENCE framing square MITER TABLE Miter lock lever pointer throat plate VIEW OF MITER TABLE SQUARE WITH FENCE Fig. 13 MITER FENCE MITER TABLE framing square throat plate VIEW OF MITER TABLE NOT SQUARE WITH FENCE, ADJUSTMENTS ARE REQUIRED Fig. 14 MITER FENCE MITER TABLE framing square throat plate VIEW OF MITER TABLE NOT SQUARE WITH FENCE, ADJUSTMENTS ARE REQUIRED Fig. 15 16