Ryobi WS750L Operation Manual - Page 13
Operation - laser adjustment
View all Ryobi WS750L manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
OPERATION on/off SWITCH See Figure 20, page 24. Your saw is equipped with an on/off switch that has a built-in locking feature. This feature is intended to prevent unauthorized and possible hazardous use by children and others. TO TURN THE SAW ON: With the switch key inserted into the switch, lift the switch button to turn ON. NOTE - If using the pumpless flow system: When on/off switch is turned on, immediately turn on the flow adjustment valve. TO TURN THE SAW OFF: Press the switch button down to turn OFF. NOTE - If using the pumpless flow system: When on/off switch is turned off, immediately turn off the flow adjustment valve. To lock the saw: With the saw turned OFF, pull the switch key from the switch and store in a safe, secure location. WARNING: In the event of a power failure or when the tool is not in use, turn the switch OFF and remove the switch key. This action will prevent the tool from accidentally starting when power returns. WARNING: ALWAYS make sure your workpiece is not in contact with the cutting wheel before operating the switch to start the tool. Failure to heed this warning may cause the workpiece to be kicked back toward the operator and result in serious personal injury. WARNING: To reduce the risk of accidental starting, Always make sure the switch is in the OFF position before plugging tool into the power source. using THE WATER supply valve See Figure 15, page 23. The water supply valve allows you to adjust the water flowing onto the wheel. using THE FLOW ADJUSTMENT VALVE See Figure 21, page 24. When using the pumpless flow system, this valve must be turned on and off immediately following turning the saw on or off. When using the pump, the flow adjustment valve can be used to adjust the flow of water. using THE PUMP See Figure 22, page 24. The pump recirculates w ater from the tray to the cutting wheel. Install the pump and plug it into the receptacle on the motor head. Make sure that the water supply valve on the tray is in the off position. Fill the water tray with clean water. Do not fill past the Max Fill line on the tray. Locate the "Max/Min" water flow selector on the pump. For best performance, set the flow to "Max" and use the flow adjustment valve to control the flow of water over the wheel. The pump turns on when the motor is turned on. Let the cutting wheel build up to full speed and wait for the wheel to get wet before moving the material into the wheel. using the rip guide See Figure 18, page 23. The rip guide can be used from both the left and right side of the cutting wheel. Place the rip guide in the desired position. Push the lever down to lock in place. To adjust angles: Loosen the lock knob. Set to the desired angle by moving the lower part of the rip guide left or right. Tighten the knob securely before turning on the saw. DANGER: Laser radiation. Avoid direct eye contact with light source. using the LASER guide See Figure 23, page 24. The laser guide will generate a colored line on the work surface. The laser guide is turned on or off with the switch next to the battery compartment and may be used when the saw is not turned on. 13 - English