Samsung PCK5315R User Manual (user Manual) (ver.1.0) (English) - Page 28

Storing Channels in Memory (Automatic Method), and stores them in memory.

Page 28 highlights

OPERATION Storing Channels in Memory (Automatic Method) 1 First, select the correct signal source (ANT, STD, HRC, IRC). See steps 1~4 on previous page. Press MENU, then press CH ▼ twice to highlight "SET UP." Press VOL + to access the SETUP sub-menu. "Channel set up" will be highlighted. 2 Press VOL + while "Channel set up" is highlighted. A new sub-menu will appear, and "Auto program" will be highlighted. 3 Press VOL + again. The TV will begin memorizing all of the available channels. 4 After all the available channels are stored, the Auto program menu reappears. Press Menu three times to exit. Note: Channel auto program does not function when the V-chip is active. ▼ The TV automatically cycles through all of the available channels and stores them in memory. This takes about one to two minutes. Press VOL+ at any time to interrupt the memorization process and return to the Setup menu. 3.6 CHAPTER THREE: TV OPERATION

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58

3
Press
VOL +
again.
The TV will begin
memorizing all of the
available channels.
4
After all the available
channels are stored, the
Auto program menu
reappears. Press Menu
three times to exit.
3
.6
C
HAPTER
T
HREE
: TV O
PERATION
O
PERATION
Storing Channels in Memory (Automatic Method)
The TV automatically cycles
through all of the available channels
and stores them in memory. This
takes about one to two minutes.
Press
VOL+
at any time to interrupt
the memorization process and return
to the Setup menu.
2
Press
VOL +
while
“Channel set up” is high-
lighted. A new sub-menu
will appear, and “Auto
program” will be
highlighted.
1
First, select the correct
signal source (ANT, STD,
HRC, IRC). See steps 1~4
on previous page.
Press
MENU
, then press
CH
twice to highlight
“SET UP.”
Press
VOL +
to access
the SETUP sub-menu.
“Channel set up” will be
highlighted.
Note: Channel auto program does not function when the
V-chip is active.