Samsung SP50L6HX Owner Instructions - Page 11

Connecting to an Aerial or Cable Television Network To view television channels correctly, a signal must be received by the set from one of the following sources: ◆ An outdoor aerial ◆ A cable television network ◆ A satellite network 1 In the first three cases, connect the aerial or network input cable to the ANT IN jack on the rear of the television. 2 If you are using an indoor aerial, you may need to turn it when tuning your television until you obtain a picture that is both sharp and clear. For further details, refer to: ◆ "Storing Channels Automatically" on page 16. ◆ "Storing Channels Manually" on page 17. ➢ When installing or re-installing your TV, be sure to use the supplied coaxial antenna cable. If you connect using a different coaxial cable, there is risk of noise or interference to the screen image. (You must not use another general purpose cable. Use the 3M/5M/7M cable supplied by Samsung.) Rear of the TV or Cable Television Network Connecting a Satellite Receiver or Decoder In order to watch television programmes broadcast via a satellite network, you must connect a satellite receiver to the rear of TV. Also, in order to descramble a coded transmission signal, you must connect a decoder to the rear of TV. ◆ Using a RCA cable Connect the receiver (or decoder) RCA cable to one of the RCA connectors on the rear of the television. ◆ Using a coaxial cable Connect a coaxial cable to the: - Receiver (or Decoder) output socket. - Television aerial input socket. ➢ If you wish to connect both a satellite receiver (or decoder) and a VCR, you should connect the: ◆ Receiver (or Decoder) to the VCR ◆ VCR to the television Otherwise, connect the receiver (or decoder) directly to the television. Rear of the TV Coaxial cable RCA cable Satellite Receiver/Decoder English - 11