Samsung TL34HD User Manual (ENGLISH) - Page 76
About the battery
UPC - 044701009719
View all Samsung TL34HD manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 76 highlights
Camera maintenance About the battery Use only Samsung-approved batteries. Battery specifications Mode Type Cell capacity SLB-1137D Lithium-ion battery 1100mAh Shooting time / Number of photos Videos Approx. 90min Shooting conditions (when the battery is fully charged) Record videos at 640x480 resolution and 30fps. • The figures above are measured by Samsung's standards and may differ depending on usage. • Several videos were recorded in succession to determine the total recording time. Voltage 3.7V Notes about charging the battery Charging time Approx. 150min • If the indicator light is off, make sure that the battery is inserted (when the camera is switched off) correctly. • Turn off your camera when charging. • Turn on your camera after charging the battery for more than 10 Battery life minutes. Shooting time / Number of photos Shooting conditions (when the battery is fully charged) This is measured under the following conditions: in the 2 mode, 14M resolution, Fine quality, OIS on. • Using flash or recording videos depletes the battery quickly. Charge the battery until the indicator light turns green. • If the indicator light blinks in red or does not illuminate, reconnect the cable, or remove the battery and insert it again. • If you charge the battery when it is warm, the indicator light may turn orange. Charging will start when the battery cools down. 1. Set the flash option to Fill in, take a Photos Approx. 100min/ Approx. 200 single shot, and zoom in or out. 2. Set the flash option to Off, take a single shot, and zoom in or out. 3. Perform steps 1 and 2 for 30 seconds and repeat for 5 minutes. Then turn off the camera for 1 minute. 4. Repeat steps 1 to 3. Notes about charging with a computer connected • Use only the provided USB cable. • The battery may not be charged when: - you use a USB hub - other USB devices are connected to your computer - you connect the cable to the port on the front side of your computer - the USB port of your computer does not support the Power output standard (5V, 500mA) Appendix 75