Sanyo CE42LM4N-NA Owner's Manual for POA-LN01 - Page 42
How to set Network configuration on network board to default
UPC - 086483065149
View all Sanyo CE42LM4N-NA manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 42 highlights
Serial Port Use If you forgot current network configuration, (IP address, subnet mask,password DNS, and default gateway), you can set them to default value via the serial port (RS232C). How to set Network configuration on network board to default 1 Send below command (ASCII) to network board W_DEFAULT + [CR] "_" means space. 2 Network board will be rebooted. It takes about 40 seconds. 3 Network board starts with default network configuration. 42
42
Serial Port Use
If you forgot current network configuration, (IP address, subnet mask,password DNS, and
default gateway), you can set them to default value via the serial port (RS232C).
1
Send below command (ASCII) to network board
W_DEFAULT + [CR]
“_” means space.
2
Network board will be rebooted. It takes about 40 seconds.
3
Network board starts with default network configuration.
How to set Network configuration on network board to default