Sanyo DMP-692 Owners Manual - Page 12

REMOTE CONTROL 1 2 3 16 4 5 17 6 7 18 8 PRESET / MENU 19 9 20 10 11 21 12 13 22 14 15 DMP-692 Using The Remote Control 1 . Remote Control Transmitter 2 . STANDBY/ON Button 3 . MUTE Button 4 . VOLUME Button 5 . FM ST/MO Button 6 . DBBS Button 7 . SLEEP Button 8 . TIME SET / MEMORY Button 9 . PRESET / MENU - Button 10. MENU Button 11. TUNE / SKIP Button 12. ENTER Button 13. iPod SELECT Button 14. PLAY/PAUSE / Button 15. SNOOZE / DIMMER Button 16. VOLUME Button 17. EQ Button 18. ALM 2 Button 19. ALM 1 Button 20. PRESET / MENU + Button 21. TUNE / SKIP Button 22. MODE Button The CR2032 lithium battery is already installed in the remote control. Pull out the small mylar insulation tab as shown in the illustration to begin using the remote control. PULL To use the remote controller, point the remote control transmitter on the remote control toward the remote control receiver on the front panel of the main unit and press the desired button. The effective range of the remote controller is approximately 20 feet. Please note that bright sunlight or artificial light may interfere with the proper operation of the remote control. Battery Replacement When the remote operation becomes weak or intermittent, it is time to replace the remote control battery. Pull out the battery holder, remove the old battery and install a new CR2032 battery in the holder as shown in the illustration. Slide the holder back into the remote control. NOTE: If the battery is installed incorrectly the remote control will not work. 11