Sanyo PDG-DXL2000 RS232C Expand - Page 17

PDG-DXL2000 Expand Serial Command Functional Specifications 8. Functional Execution Command 8.1 Format 1. PC issues commands in format as below: Pattern1 : "CF_COMMAND" [CR] Pattern2 : "CF_COMMAND_"%1 [CR] CF_ : Header COMMAND : Character line %1 : Parameter (Character line) _ : Space (To separate COMMAND and Parameter) 2. The projector decodes the received command and when it is ready to receive the next command, it returns the response. "000" [CR] : (0x06, 0x0D) When receiving Functional Execution Command "nnn" [CR] : Except "000" , when it is unable to execute command by any specific reason. See Error Code Table for details 3. When the received data cannot be decoded, the projector returns "?" [CR] 8.2 Transfer Example When setting projector's total dots to 1344 by Expand Serial Command PC → PJ: "CF_TDOTS_1344" [CR] PC ← PJ: "000"[CR Acceptable 8.3 Operation Requirements 1) Functional Execution Command is limited when the projector status is as below. However, Status Read Command is effective even under these conditions. Projector Status In Standby status Countdown in process Cooling down in process Cooling down in process due to Abnormal Temperature Abnormal Temperature Power Failure (For 60 seconds after Power Failure occurred) Power Save / Cooling down in process Power Save in process Available Functional Execution Command C00: POWER ON only C00: POWER ON (Terminates Countdown) C01: POWER OFF C02: POWER OFF (Terminates Countdown) N/A N/A N/A N/A N/A C00: POWER ON C01: POWER OFF Note:) When the projector receives the other command in this above status, it returns error code to show the status. When the projector receives the following functional execution commands, OSD menu is closed except for pop-up menu 2) Functional Execution Commands are invalid when Eco mode is selected in Standby mode of Setting menu and projector is in standby 16/72