Sanyo PLC-XP100L Owners Manual - Page 59
Lamp Replacement, Top Panel - bulb
UPC - 086483068263
View all Sanyo PLC-XP100L manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 59 highlights
Maintenance and Care Lamp Replacement When the projection lamp of the projector reaches its end of life, the Lamp replacement icon appears on the screen and LAMP REPLACE indicator lights orange. Replace the lamp with a new one promptly. The timing when the LAMP REPLACE indicator should light is depending on the lamp mode. Top Panel Filter cover Lamp cover Lamp replacement icon LAMP REPLACE indicator ✔Note: • The Lamp replacement icon will not appear when the Display function is set to "Off" (p.48), during "Freeze" (p.28), or "No show" (p.29). Screw Follow these steps to replace the lamp. 1 Turn off the projector and unplug the AC power cord. Let the projector cool for at least 45 minutes. 2 Open the filter cover. (p.57) 3 Loosen the screw and open the lamp cover. Pull out the lamp by using the built in handle. 4 Replace the lamp with a new one. Make sure that the lamp is properly and fully inserted. 5 Close the lamp cover and secure the screw. 6 Close the filter cover. 7 Connect the AC power cord to the projector and turn on the projector. 8 Reset the Lamp counter (p.60) ✔Note: • Be sure to insert the lamp in the correct direction. • Do not reset the Lamp counter when the projection lamp is not replaced. Lamp Handle CAUTION Allow a projector to cool for at least 45 minutes before you open the lamp cover. The inside of the projector can become very hot. CAUTION For continued safety, replace with a lamp of the same type. Do not drop the lamp or touch the glass bulb! The glass can shatter and may cause injury. 59