Sanyo PLC XU115 Instruction Manual, PLC-XU115 - Page 64
after turning off power°, The setting does not remain
UPC - 086483071393
View all Sanyo PLC XU115 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 64 highlights
Appendix No image - Check the connection between your computer or video equipment and the projector. See pages 19-21. - See if the input signal is correctly output from your computer. Some laptop computers may need to change the setting for monitor output when connecting to a projector. See your computer's instruction manual for the setting. - It takes about 30 seconds to display an image after turning on the projector. See page 22. - Check the Input signal, color system, video system or computer system mode. - Make sure the temperature is not out of the specified Operating Temperature (41˚F-95˚F [5˚C-35˚C]). - When "No Show" is operating, the image cannot be displayed. Press the NO SHOW button or any other button on the remote control. No sound - Check the audio cable connection from audio input source. - Adjust the audio source. - Press the Volume + button. See page 27. - Press the Mute button. See page 27 - When the AUDIO OUT is plugged-in, the projector's built-in speaker is not available - Is the image projected? You will hear the sound only when the image is projected. The color is strange. - Check the Input signal, color system,video system or computer system mode. - Make sure the "Blackboard" is not selected on Image select menu.(see page 36,43) Some displays are not seen during the operation. - Check the Display function. See page 48. Auto PC adjustment function does not work. - Check the Input signal. Auto PC function can not work when 480p,575p.720p,480i,575i,1035i or 1080i is selected or when the digital signal is input into DVI terminal.(see Page 34 - The icon is not available in grayout when the digital signal is input. The setting does not remain after turning off power. - Make sure you selected "Store" after adjusting setting. Some settings can not be stored if not registered with "Store".(see page 45) Power management does work. - Power management function can not work while "Freeze" or "No Show" function is running.(see page 52) Capture function does not work. - Check the connection and the input signal to see if there is signal. Auto setup does not work properly. - Make sure "Off" is not selected at the Auto setup function.(see page 47 - Make sure "On" is not selected at the Ceiling function.(see page 51) Auto keystone function does not work even when the projector is tipped. - Make sure the Auto keystone function is not set to "Manual". Press the AUTO SET UP button on the top control.(see page 26,47 64