Sanyo PLV Z1 Owners Manual - Page 44
Appendix - bulb
UPC - 086483045776
View all Sanyo PLV Z1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 44 highlights
Appendix Lamp Replacement When the life of the projection lamp draws to an end, the LAMP REPLACE indicator lights yellow. When this indicator lights yellow, replace the projection lamp with a new one promptly. This indicator lights yellow when the life of the projection lamp draws to an end. Replace the Projection Lamp with a new one. TOP CONTROL WARNING TEMP. READY LAMP REPLACE ON-OFF LAMP ALLOW A PROJECTOR TO COOL, FOR AT LEAST 45 MINUTES BEFORE YOU OPEN LAMP COVER. THE INSIDE OF A PROJECTOR CAN BECOME VERY HOT. CAUTION FOR CONTINUED SAFETY, REPLACE WITH A LAMP ASSEMBLY OF THE SAME TYPE. DO NOT DROP A LAMP ASSEMBLY OR TOUCH A GLASS BULB! THE GLASS CAMNENSU HATTER AND MAY CAUSE INJURY. SELECT INPUT Follow these steps to replace the lamp assembly. 1 Turn off the projector and disconnect AC plug. Allow the projector to be cooled for at least 45 minutes. 2 To remove the Lamp cover, remove the screw with a screwdriver. 3 Remove 2 screws with a screwdriver and pull out the Lamp assembly by grasping the handle. 4 Replace the Lamp assembly with a new one and tighten the 2 screws back into position. Make sure that the Lamp assembly is set properly. Replace the Lamp cover and tighten the screw. 5 Connect the AC Power Cord to the projector and turn on the projector. 6 Reset the Lamp Replace Counter. Refer to "Lamp Replace Counter" on the next page . NOTE : Do not reset the Lamp Replace Counter when the Projection lamp is not replaced. SCREW SCREW LAMP COVER HANDLE LAMP ASSEMBLY SCREW ORDER REPLACEMENT LAMP Replacement Lamp can be ordered through your dealer. When ordering a Projection Lamp, give the following information to the dealer. G Model No. of your projector : G Replacement Lamp Type No. : PLV-Z1 / PLV-Z1BL POA-LMP54 (Service Parts No. 610 302 5933) 44