Sanyo VCC-HD5600 VCC-HD5600 Setup and Summary Manual - Page 4
Installation
View all Sanyo VCC-HD5600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
Installation 1. Installing the power board unit ⴺ Place the supplied pattern sheet on the ceiling, mark the locations and drill the holes for the cables and screws. • Pull out the cables from the ceiling. Ceiling Pattern sheet (Accessory) ⴼ Attach the supplied dust sheet (A) to the base of the power board unit and the detachable piece of the sheet (B) to the side. ■ When routing cables through side face of power board unit A C A B ⴾ Pass the cables through the slit (C) in the dust sheet. ⵀ Fix the power board unit to the ceiling using commercially available screws (4 places). Make sure to tighten the screws properly. Using screws of sizes other than specified may cause the unit to fall. Screw size (equivalent to M4/No.8) • Nominal length: 40 mm (1.6 in) or more • Head diameter: ø8.3 mm (0.3 in) B ⵂ Connect the cables and set the switches (D). "Connections" (Page 5), "Control/Address Settings (Page 9)" ⴾC ⵀ D ⵂ 3