Sanyo XL50 Instruction Manual, PLC-XL50 - Page 10
Rear Terminal, S-video In, Audio In, Audio In Computer, Audio Outvariable, Service Port, Computer In 1
![]() |
UPC - 086483069499
View all Sanyo XL50 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
Part Names and Functions Rear Terminal q w e r t y u i o !0 q SERVICE PORT This jack is used to service the projector. w COMPUTER IN 1 Connect output signal from a computer, or RGB scart 21-pin video output to this terminal (pp.16, 18). When the cable is of the longer variety, it is advisable to use this terminal and not COMPUTER IN 2/MONITOR OUT. e COMPUTER IN 2/MONITOR OUT This terminal is switchable and can be used for input from a computer or output to the other monitor. Set the terminal up as either Computer input or Monitor output properly. [Used for Monitor out, this terminal outputs only incoming signal from COMPUTER IN 1 terminal (pp. 16, 49)]. r COMPONENT IN Connect the component video output signal to these jacks (p.18). t ALARM buttons Use these buttons when setting up the Alarm function (pp.55-56). y S-VIDEO IN Connect the S-VIDEO output from video equipment to this jack (p.17). u AUDIO OUT(VARIABLE) Connect an external audio amplifier to this jack (pp.16-18). This terminal outputs sound from AUDIO IN terminal (i or !0). i AUDIO IN COMPUTER Connect the audio output (stereo) from a computer connected to w or e to this jack (pp.16, 18). o VIDEO IN Connect the composite video output from video equipment to VIDEO jack (p.17). !0 AUDIO IN Connect the audio output from video equipment connected to r, y or o to this jack. [When the audio output is monaural, connect it to L (MONO) jack (p.17, 18). 10
![](/manual_guide/products/sanyo-xl50-instruction-manual-plcxl50-cbf2954/10.png)