Sanyo XL50 Instruction Manual, PLC-XL50 - Page 62

Maintenance and Cleaning Lamp Replacement When the projection lamp of the projector reaches its end of life, the Lamp replacement icon appears on the screen and LAMP REPLACE indicator lights yellow. Replace the lamp with a new one promptly. The timing when the LAMP REPLACE indicator should light is depending on the lamp mode. Indicators LAMP REPLACE indicator WARNING: TURN OFF THE UV LAMP BEFORE OPENING THE LAMP COVER ✔Note: •The Lamp replacement icon will not appear when the Display function is set to "Off" (p.46), during "Freeze" (p.25), or "No show" (p.26). Lamp replacement icon CAUTION Allow a projector to cool for at least 45 minutes before you open the Lamp cover. The inside of the projector can become very hot. CAUTION For continued safety, replace with a lamp of the same type. Do not drop a lamp or touch a glass bulb! The glass can shatter and may cause injury. Follow these steps to replace the lamp. 1 Turn off the projector and unplug the AC power cord. Let the projector cool for at least 45 minutes. 2 Remove the screw from the lamp cover and open the cover. 3 Loosen the two (2) screws that secure the lamp. Lift the lamp out of the projector by using the handle. Lamp Cover Screw 4 Replace the lamp with a new one and secure the two (2) screws. Make sure that the lamp is set properly. Close the lamp cover and secure the screw. 5 Connect the AC power cord to the projector and turn on the projector. 6 Reset the lamp counter. See "Lamp Replacement Counter" on the next page. Screw Handle Screw ✔Note: •When replacing the projection lamp, protect the infrared remote receiver with a soft cloth to avoid damaging it. Lamp ORDER REPLACEMENT LAMP Replacement lamp can be ordered through your dealer. When ordering a projection lamp, give the following information to the dealer. ● Model No. of your projector ● Replacement Lamp Type No. : PLC-XL50 : POA-LMP121 (Service Parts No. 610 337 9937) 62