Seagate ST160LT007 Momentus Thin (.2-4K) SATA Product Manual - Page 11

Table 1: Drive specifications Drive specification Read/write power (typical) Idle mode, low power (typical) Standby/Sleep mode (typical) Voltage tolerance (including noise) Ambient temperature Temperature gradient (°C per hour max) Relative humidity Relative humidity gradient Wet bulb temperature (°C max) Altitude, operating Altitude, nonoperating (meters below mean sea level, max) Shock, operating (Gs max at 2ms) Shock, nonoperating (Gs max at 2ms) Shock, nonoperating (Gs max at 1ms) Shock, nonoperating (Gs max at 0.5ms) Vibration, operating (Swept Sine) Vibration, nonoperating Drive acoustics, sound power (bels) Idle** Seek Nonrecoverable read errors Annualized Failure Rate (AFR) Load/Unload (U/UL) cycles ST320LT007 - 9ZV142 ST320LT009 - 9WC142 ST320LT011 - 9ZVG42 ST320LT014 - 9YK142 ST250LT007 - 9ZV14C ST250LT009 - 9WC14C ST250LT011 - 9ZVG4C ST250LT014 - 9YK14C Read: 1.6W; Write: 1.9W 0.66W 0.15W *** +5V ± 10% 0° to 60°C (operating), -40° to 70°C (nonoperating) 20°C (operating) 35°C (nonoperating) 5% to 95% (operating) 5% to 95% (nonoperating) 30% per hour max 37.7 (operating) 40 (nonoperating) -304.8 m to 3,048 m (-1000 ft. to 10,000+ ft.) -304.8 m to 12,192 m (-1000 ft. to 40,000+ ft.) 350 800 1000 600 1.0 Gs (0 to peak, 5-500 Hz) 5.0 Gs (0 to peak, 5-500 Hz) 2.3 (typical) 2.5 (max) 2.5 (typical) 2.7 (max) 1 per 1014 bits read 0.50% ST160LT007 - 9ZV14D ST160LT009 - 9WC14D ST160LT011 - 9ZVG4D ST160LT014 - 9YK14D 25°C, 50% relative humidity 600,000 software-controlled power on/off cycles 20,000 hard power on/off cycles 32°C, 80% relative humidity 5°C, 80% relative humidity 5°C, 10% relative humidity 55°C, 16% relative humidity Warranty Supports Hotplug operation per Serial ATA Revision 2.6 specification 600,000 software-controlled power on/off cycles 20,000 hard power on/off cycles To determine the warranty for a specific drive, use a web browser to access the following web page: http://www.seagate.com/www/en-us/support/warranty_&_returns_assistance You will be asked to provide the drive serial number, model number (or part number) and country of purchase. After submitting this information, the system will display the warranty information for your drive. Yes (requires COMRESET from host after a hotplug event) *One GB equals one billion bytes when referring to hard drive capacity. Accessible capacity may vary depending on operating environment and formatting. **During periods of drive idle, some offline activity may occur according to the S.M.A.R.T. specification, which may increase acoustic and power to operational levels. ***Typical notebooks will pull power to the drive when entering S3 and S4; while in the S3 and S4 states, drive sleep and drive standby modes will not contribute to battery power consumption. Momentus Thin Product Manual, Gen-2 Rev. D 5