Seagate ST160LT007 Momentus Thin (.2-4K) SATA Product Manual - Page 14

3.8 Start/stop times Time to ready Power-on to Ready (sec) Standby to Ready (sec) Typical 3.5 3.0 Max @ 25°C 4.0 3.0 3.9 Power specifications The drive receives DC power (+5V) through a native SATA power connector. 3.9.1 Power consumption Power requirements for the drives are listed in the table on page 8. Typical power measurements are based on an average of drives tested, under nominal conditions, at 25°C ambient temperature. These power measurements are done with Interface Power Management modes like HIPM and DIPM enabled. • Spinup power Spinup power is measured from the time of power-on to the time that the drive spindle reaches operating speed. • Seek mode During seek mode, the read/write actuator arm moves toward a specific position on the disk surface and does not execute a read or write operation. Servo electronics are active. Seek mode power is measured based on three random seek operations every 100ms. This mode is not typical. • Read/write power and current Read/write power is measured with the heads on track, based on three 63 sector read or write operations every 100ms. • Idle mode power Idle mode power is measured with the drive up to speed, with servo electronics active and with the heads in a random track location. • Standby mode During Standby mode, the drive accepts commands, but the drive is not spinning, and the servo and read/ write electronics are in power-down model Table 3: DC power Power dissipation Spinup (max) Seek Read Write Idle, performance* Idle, active* Idle, low power mode* Standby** Sleep +5V input average (25° C) 1.00A 1.6W 1.6W 1.9W 1.3W 0.90W 0.66W 0.15W 0.15W *During periods of drive idle, some offline activity may occur according to the S.M.A.R.T. specification, which may increase acoustic and 8 Momentus Thin Product Manual, Gen-2 Rev. D