Sharp AR-162S AR-162S Operation Manual - Page 31
Toner cartridge life
View all Sharp AR-162S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 31 highlights
STATUS INDICATORS TONER CARTRIDGE REPLACEMENT 5 Gently insert the toner cartridge along the guides until it locks in place while pushing the lock release lever. If dirt or dust is adhered to the toner cartridge, remove it before installing the cartridge. 6 Remove the tape from the shutter. Pull the shutter out of the toner cartridge as shown in the illustration. Discard the shutter. 7 Close the front cover by pushing both sides with your hands and then close the side cover by pressing the handle on the cover. The indicator will go out. When closing the covers, be sure to close the front cover securely and then close the side cover. If the covers are closed in the wrong order, the covers may be damaged. Even after a new toner cartridge is installed, the START key indicator may not light up, indicating copying cannot be restarted (toner is not sufficiently fed). In this case, open and close the side cover. The copier will feed toner again approximately 2 minutes and then copying can be restarted. Toner cartridge life To find out the approximate quantity of toner remaining, follow the procedure below. 1 Press and hold the light ( ) key for more than 5 seconds until all the alarm indicators ( , , , , and ) blink and "- -" appears in the copy quantity display. 2 Press and hold the copy ratio display ( ) key for more than 5 seconds. G The approximate quantity of toner remaining will be indicated in the copy quantity display as a percentage. ( "100", "75", "50", "25", or "10" is displayed.) When the percentage is less than 10%, "LO" will be displayed. 3 Press the light ( ) key. G All the alarm indicators will go out. 29 Toner cartridge replacement