Sharp AR M277 AR-M237 AR-M277 Operation Manual Suite - Page 131
Using the RSPF, Using the document glass, Press the [START] key
View all Sharp AR M277 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 131 highlights
BASIC OPERATIONS Entering a pause. PAUSE AX MEMORY:100% AUTO RECEPTION NEXT ADD B SUB A If you need to insert a pause between digits to access an outside line or dial an international number, touch the [PAUSE] key in the upper right-hand corner of the screen. Each time you touch the [PAUSE] key, a hyphen ("-") appears and a 2-second pause* is inserted. After entering a number, you can also touch the [PAUSE] key to enter a hyphen, and then enter another number using the numeric keys or a rapid key. This connects the numbers together (Chain dialing). *The duration of each pause can be changed with the key operator program. ("PAUSE TIME SETTING" (p.97)) Note Group keys cannot be used for chain dialing. Using the RSPF 7 Press the [START] key ( ). Scanning begins. If a job is not in progress and the telephone line is not being used, the destination is dialed while the original is being scanned. (This is called "Quick on-line"; see page 14). If there is a previously stored job or a job is in progress, or if the line is being used, all pages of the document are scanned into memory and stored as a transmission job. (This is called memory transmission: the destination is automatically called and the document transmitted after previously stored jobs are completed.) If scanning is completed normally, a beep sounds to inform you that the transmission job is stored and "JOB STORED." appears in the message display. Using the document glass 7 Press the [START] key ( ). The original is scanned and the [READ-END] key appears. 8 If you have another page to scan, change pages and then press the [START] key ( ). Repeat this sequence until all pages have been scanned. You can change the original size, 2 resolution, and exposure settings as needed for each page. If no action is taken for one minute (the [START] key ( ) is not pressed), scanning automatically ends and the transmission job is stored. 9 After the final page is scanned, touch the [READ-END] key. A beep sounds to inform (Pg.No. 2) L. you that the transmission job is stored and "JOB ESS [READ-END] STORED." appears in the message display. READ-END (The destination is automatically called and the document transmitted after previously stored jobs are completed.) Open the RSPFand remove the document. Note Canceling transmission To cancel transmission while "SCANNING ORIGINAL" appears in the display or before the [READ-END] key is pressed, press the [CLEAR] key ( ) or the [CLEAR ALL] key ( ). To cancel a transmission job that is already stored, press the [JOB STATUS] key and cancel the job as explained on page 24. Caution • If the machine sounds two beeps during or at the end of transmission and an error message appears in the touch panel, refer to "WHEN AN ALARM SOUNDS AND A WARNING MESSAGE IS DISPLAYED" (p.86) to fix the problem. • If the power is turned off or there is an interruption in the power supply while an original is being scanned using the RSPF, scanning will stop and a misfeed will occur. After the power is restored, remove the misfed original as explained in "MISFEED REMOVAL" in the operation manual for copier. 13