Sharp ARNC5J Service Manual - Page 9
Notes during/after uploading - ar nc5j driver
View all Sharp ARNC5J manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
1) Single selection When only one printer is selected from the list on the main menu: First the upload start confirmation display is shown. Selecting YES in this menu deletes the firmware and starts uploading. During uploading, the process indication bar is displayed on the firmware upload menu. After completion of uploading, the firmware upload menu is closed and the control returns to the main menu. 2) Plural selection (without confirmation) When two or more printers are selected from the list on the main menu, and a check mark is not put to "When uploading to multiple units, display a confirmation prompt for each unit." In this case, the upload start confirmation menu is displayed only once when starting the first writing. Selecting YES in this menu starts writing the firmware to the selected printers continuously. The operations during and after writing are the same as "Single selection." 3) Plural selection (with confirmation) When two or more printers are selected from the list on the main menu, and a check mark is put to "When uploading to multiple units, display a confirmation prompt for each unit." In this case, the upload start confirmation menu is displayed and delete/uploading of the firmware is made for each of the selected printers. (This series of operations is repeated for each printer.) If NO is selected in the confirmation menu, uploading is not performed and the control goes to the confirmation menu of the next printer. The operations during and after writing are the same as "Single selection." E. Test print After selecting a desired printer from the list, select COMMUNICATION a TEST PRINT on the menu or press the TEST PRINT button, and the test print of the selected printer will be performed. This function is used for troubleshooting. Similarly to the firmware uploading, there are three patterns: Single selection, Plural selection (without confirmation), and Plural selection (with confirmation). If the test print packet that is sending fails, an error message is displayed. (Refer to "5. Error message list." In the case of normal completion, no message is displayed. Test print confirmation menu (Signal selection/Plural selection (with confirmation)) Test print confirmation menu (Plural selection (without confirmation)) Upload start confirmation menu (Single selection/Plural selection (with confirmation)) Upload start confirmation menu (Plural selection (without confirmation)) Firmware delete menu Firmware upload menu 4. Notes during/after uploading During and after uploading, take care of the following notes: (a) During uploading, the printer power should not be turned off and the network cable should not be disconnected. If they should, uploading will not performed normally and the firmware will be broken. If the firmware should be broken due to an accident during uploading, retrieval by the version up tool may not be responded. In such a case, reboot the printer with the jumper switch No. 1 at ON, and the network card will be booted in the forcible loader mode to make responding to retrieval. This operation is performed similarly to both cases when the IPX/ SPX protocol is used and when the packet driver is used. There are no limitations. (b) When the composition of the setup information differs between different versions before and after uploading, the content of setup may be broken after completion of uploading. (This information will be given with version-up bin file.) In such a case, the setup shadd be returned to the initial factory setup. Then use the setup tool and a Web browser to make setup again. AR-NC5J/NC5JG/NC5JW - 8