Sharp BDMPC41 BD-MPC41U Operation Manual - Page 77

SETTINGS Software Update Settings In this system, the software version can be updated using either one of the following methods. • Auto Update from Network • Manual Update from Network • Manual Update from USB memory device Auto Update from Network This function allows you to perform the update by accessing an internet connection automatically to check if there is a new firmware version every time the system is turned on. When using this function, it is required to perform the following settings in advance. NOTE • Make sure that the LAN cable is connected to this system. (See page 32.) • Make sure to perform the communication settings. (See pages 71-73.) • It may take time to access and download the update depending on the internet connection and other factors. CAUTION • Do not remove the LAN cable or unplug the AC cord while downloading or updating software. Update process 1 When this system is turned on, the internet connection starts automatically. • "Accessing..." blinks on the screen. • The current version of this unit software and the latest version of the update file on the network are displayed when latest version of firmware has been found. To update this system software with update file, select "Yes", and go to step 2. Latest version of firmware has been found. Firmware update is available. Proceed with update? Current Version : xxxxxxxxxx Latest Version : yyyyyyyyyy If "Yes" will be selected, version update will start. Yes No • If the latest firmware version has been already updated, nothing is displayed on the screen. 2 Press ENTER to start updating. Downloading latest firmware... Version : yyyyyyyyyy Settings Buttons under the cover Setup 1 Press BD/AUX repeatedly to select DISC function. • The same operation can be performed by pressing SELECTOR repeatedly on the main unit. 2 Press HOME to display the menu screen. 3 Press a/b to select "Settings", then press d or ENTER. 4 Press a/b to select "Software Update Settings", then press d or ENTER. 5 Press a/b to select "Auto Update Setting", then press d or ENTER. 6 Press a/b to select "Yes", then press ENTER. • After this, an internet connection will be made automatically every time this system is turned on. 30% 3 When the software is successfully updated, a screen is displayed indicating that the update process is completed. • If the update has failed, an error message appears. Retry to perform the update after checking if the LAN cable connection (page 32) and internet settings (pages 71-73) are performed properly. NOTE • If the update of the AUDIO section starts automatically after the software update, the STANDBY indicator will blink. When the update is completed, the STANDBY indicator stops blinking and lights up. (The power will be turned off automatically.) Never disconnect the AC power cord until this status is reached. 4 If prompted by a displayed message to turn off the system, press POWER to turn it off before using again. 75