Sharp CD-DH790N CD-DH790N Operation Manual - Page 11

Listening to a CD or MP3/WMA disc (continued) Advanced CD or MP3/WMA disc playback ■ Disc playback 1 Press the ON/STAND-BY button to turn the power on. 2 Press the CD button on the remote control or FUNCTION button repeatedly on the main unit to select CD function. CD 3 Press the OPEN/CLOSE button to open the disc tray. USB 4 Place the disc on the disc tray, label side up. TAPE ONP/SOTWANEDR-BY FUNCTION VOL PUSH OPEN 5 Press the OPEN/CLOSE AUDIOIN PHONES button to close the disc tray. 6 Press the / (CD / ) button to start playback. After the last track is played, the unit will stop automatically. Caution: ● Do not place two discs in one disc tray. ● Do not play discs of special shapes (heart, octagon, etc). It may cause malfunctions. ● Do not push the disc tray while it is moving. ● If the power fails while the tray is open, wait until the power is restored. ● If TV or radio interference occurs during CD operation, move the unit away from the TV or radio. ● Be sure to place 3" (8 cm) disc in the middle of the disc tray. ● Due to the structure of the disc information, it takes longer to read an MP3/WMA disc than a normal CD (approximately 20 to 90 seconds). Notes for CD or MP3/WMA disc: ● When the end of the last track is reached during fast forward, "END" will appear on the display and CD operation will be paused. When the beginning of the first track is reached during fast reverse, the unit will enter the playback mode (only for CD). ● Rewritable multi-session discs with unfinished writing, can still be played. ■ Various disc functions Function Play Main unit Remote control Operation Press in the stop mode. Stop Pause Track up/ ____ down Fast forward/ reverse ____ Press in the playback mode. Press in the playback mode. Press the / button to resume playback from the paused point. Press in the playback or stop mode. If you press the button in the stop mode, press the / button to start the desired track. Press and hold down in the playback mode. Release the button to resume playback. ■ Direct track search By using the Direct Search buttons, the desired tracks on the current disc can be played. Use the Direct Search buttons on the remote control to select the desired track while playing the selected disc. ● The Direct Search buttons allow you to select up to number 9. ● When selecting number 10 or higher, use the "10+" button. A. For example, to choose 13 1 Press the "10+" button once. 2 Press the "1" button. 3 Press the "3" button. Selected track number B. For example, to choose 130 1 Press the "10+" button twice. 2 Press the "1" button. 3 Press the "3" button. 4 Press the "0" button. Notes: ● A track number higher than the number of tracks on the disc cannot be selected. ● During random play, direct search is not possible. To stop playback: Press the (CD ) button. ■ Repeat play Repeat play can play one track, all tracks or a programed sequence continuously. To repeat one track: Press the PLAY MODE button repeatedly until "1-REPEAT" appears. Press the / (CD / ) button. To repeat all tracks: Press the PLAY MODE button repeatedly until "ALL REPEAT" appears. Press the / (CD / ) button. To repeat desired tracks: Perform steps 1 - 5 in "Programed play" section on page 11 and then press the PLAY MODE button repeatedly until "ALL REPEAT" appears. To cancel repeat play: Press the PLAY MODE button repeatedly until "NORMAL" appears and " " disappears. E-10