Sharp CD-DH790N CD-DH790N Operation Manual - Page 18

Timer and sleep operation (Remote control only) ■ Timer playback Before setting timer: ● Check that the clock is set to the correct time (refer to page 6). If it is not set, you cannot use the timer function. CD USB ● For timer playback: Plug in USB or load discs or dock iPod to be played. TAPE Timer playback: The unit turns on and plays the desired source (CD, TUNER, USB, iPod, AUDIO IN, TAPE) at a preset time. This unit has 2 types of timer: ONCE TIMER and DAILY TIMER. Once timer: Once timer play works for one time only at a preset time. Daily timer: Daily timer play works at the same preset time every day. For example, set the timer as a wake-up call every morning. Using the once timer and daily timer in combination: For example, use the once timer to listen a radio program, and use the daily timer to wake up. 1 Set the daily timer (pages 17 - 18). 2 Set the once timer (pages 17 - 18). 1 minute or more Daily timer Once timer Start Stop Start Stop 1 Press the ON/STAND-BY button to turn the power on. 2 Press and hold the CLOCK/TIMER button. 3 Within 10 seconds, press the or button to select "ONCE SET" or "DAILY SET", and press the MEMORY button. Set the clock to the correct time if "ONCE SET" or "DAILY SET" does not appear. 4 Within 10 seconds, press the or button to select "TIMER SET", and press the MEMORY button. 5 To adjust the hour, press the or then press the MEMORY button. button and 6 To adjust the minutes, press the or then press the MEMORY button. button and 7 Set the time to finish as in steps 5 and 6 above. 8 To select the timer playback source (CD, TUNER, USB, iPod, TAPE or AUDIO IN), press the or button. Press the MEMORY button. When you select the tuner, select a station by pressing the or button, and then press the MEMORY button. If a station has not been programed, "NO PRESET" will be displayed and timer setting will be canceled. 9 Adjust the volume using the VOLUME control, and then press the MEMORY button. Do not turn the volume up too high. 10 Press the ON/STAND-BY button to enter the power stand-by mode. The "TIMER" indicator lights up and the unit is ready for timer playback. MINI COMPONENT SYSTEM CD-DH790 POWER ON/STAND-BY FUNCTION VOL AUDIO IN PUSH OPEN 11 When the preset time is reached, playback will start. The volume will increase gradually until it reaches the preset volume. The " " indicator will blink during timer playback. The "DAILY" indicator will blink during timer playback. E-17