Sharp CD-DH790N CD-DH790N Operation Manual - Page 9

Listening to the iPod (continued) ■ To insert iPod adaptor 1 Press the ON/STAND-BY button to turn the power on. 2 Insert the iPod adaptor into the iPod dock and connect your iPod. iPod (bottom) iPod Dock connector POWER ON/STAND-BY MINI COMPONENT SYSTEM CD-DH790 POWER ON/STAND-BY FUNCTION VOL iPod adaptor (not supplied) iPod dock iPod connector CD USB TAPE ■ iPod playback 1 Press the ON/STAND-BY button to turn the power on. 2 Press the iPod button on the remote control or FUNCTION button repeatedly on the main unit to select iPod function. 3 Insert iPod unit in iPod dock of main unit. 4 Press the / button to start playback. ■ To disconnect iPod Simply remove the iPod from the iPod dock. It is safe to do so even during playback. ■ Navigating the iPod menus 1 Press the MENU button to view the menu on iPod unit. Press it again to go back to previous menu. 2 Use the TUNING ( or ) button on the remote control to select an item on the menu and then press ENTER button. Note: When navigating the iPod menus with remote control, do not operate any of the buttons on the iPod unit. The volume level is adjusted by pressing the VOL (+ or -) button on the main unit or the remote control. Adjusting the volume on the iPod unit gives no effect. iPod operation: The operations described below depend on the generation iPod you are using. System on operation: When the main unit is powered on, the iPod unit will automatically power on when docked in the unit (including TIMER function/exclude USB function). System off (stand-by operation): When the main unit is turned to stand-by mode, the docked iPod unit will automatically turn to stand-by mode. E-8