Sharp CD-DH790N CD-DH790N Operation Manual - Page 17

Listening to a cassette tape Before playback: ● For playback, use normal or low-noise tapes for the best sound. (Metal or CrO2 tapes are not recommended.) ● Do not use C-120 tapes or poor-quality tapes, as they may cause malfunctions. ● Before loading a tape into the cassette compartment, tighten the slack with a pen or a pencil. POWER ON/STAND-BY MINI COMPONENT SYSTEM CD-DH790 POWER ON/STAND-BY FUNCTION VOL AUDIO IN PHONES PUSH OPEN CD USB TAPE TAPE ■ Tape playback 1 Press the ON/STAND-BY button to turn the power on. 2 Press the FUNCTION button on main unit repeatedly or TAPE button on remote control to select TAPE function. 3 Open the cassette door VOL VOL by pushing the area AUDIO IN marked " PUSH OPEN". PHONES AUDIO IN PHONES POUPSEHN PUSH OPEN 4 Load a cassette into the cassette compartment. M I N I C O M PCOD-NDHE79N0 T S Y S T E M ONP/SOTWANEDR-BY FUNCTION VOL OPEN/ CLOSE AUDIO IN PHONES 5 Press the / (TAPE ) button to start playback. Auto power on function: When you press any of the following buttons, the unit turns on. ● TAPE button (remote control): The unit turns on and the "TAPE" function is activated. ● / button on the main unit: The unit turns on and playback of the last function starts (iPod, CD, TUNER, USB, AUDIO IN, TAPE). Auto power off function: In the stop mode of tape operation, the main unit enters the stand-by mode after 15 minutes of inactivity. ■ Various tape functions Function Tape playback Main unit Remote control Operation Press in the stop mode. Stop Fast ____ forward/ Fast rewind Press in the playback, fast forward or fast rewind mode. Press in the playback or stop mode. Caution: ● To remove the cassette, press the (TAPE ) button, and then open the compartment. ● If a power failure occurs during tape operation, the tape head will remain engaged with the tape and the cassette door will not open. In this case, wait until the power is restored. E-16