Sharp CD-DH790N CD-DH790N Operation Manual - Page 6

System connections Make sure to unplug the AC power cord before making any connections. AM loop antenna Installing the AM loop antenna < Assembling > < Attaching to the wall > TV To video input jack Video cable (not supplied) wall screws (not supplied) FM antenna Right speaker Left speaker Red Black AC outlet (AC 120 V ~ 60 Hz) ■ Antenna connection ■ Demonstration mode Supplied FM antenna: Connect the FM antenna wire to the FM 75 OHMS jack and position the FM antenna wire in the direction where the strongest signal can be received. Outdoor FM antenna: Use an outdoor FM antenna (75 ohms coaxial cable) for better reception. When an outdoor FM antenna is used, disconnect the supplied FM antenna wire. ● The first time the unit is plugged in, the unit will enter the demonstration mode. You will see words scroll. ● To cancel the demonstration mode, press the DEMO button (remote control) during power stand-by mode. The unit will enter the low power consumption mode. ● To return to the demonstration mode, press the DEMO button again. Supplied AM loop antenna: Connect the AM loop antenna to the AM and GND terminals. Position the AM loop antenna for optimum reception. Place the AM loop antenna on a shelf, etc., or attach it to a stand or a wall with screws (not supplied). Note: Placing the antenna on the unit or near the AC power cord may cause noise pickup. Place the antenna away from the unit for better reception. ■ Connecting iPod to a TV The iPod with photo and video can be viewed by connecting to a TV/ monitor. If the TV/monitor has a video input, connect it to the VIDEO OUT jack on the rear of the unit. ■ Speaker connection Note: Please make sure to set iPod unit to either NTSC or PAL to match your ● Connect the black wire to the minus (-) terminal, and the red wire to the TV signal. Please visit Apple's homepage for further information. plus (+) terminal. ● Use speakers with an impedance of 4 ■ AC power connection ohms or more, as lower impedance speakers can damage the unit. ● Do not mistake the right and the left channels. The right speaker is the one After checking all the connections have been made correctly, plug the AC power cord of this unit into the AC outlet. If you plug in the unit first, the unit will enter the stand-by mode. on the right side when you face the unit. ● Do not let the bare speaker wires touch each other. Incorrect Note: Unplug the AC power cord from the AC outlet if the unit will not be in use for a prolonged period of time. ● Do not allow any objects to fall into or to be placed in the bass reflex ducts. ● Do not stand or sit on the speakers. You may be injured. E-5